3D Printer Power Usage and adding an Uninterruptible Power Supply! Upgrade Part 3

Support me on Patreon! https://www.patreon.com/HoffmanEngineering

I add a Uninterruptible Power Supply (UPS) to my setup. Its basically a giant battery that’ll supply power to my computer and 3D printer if the power goes out. This UPS can also display how much energy the connected devices are drawing, so I use that to gather information on how much power my printer and computer consumes!

Thank you all for watching! Questions/Comments? Leave them in the comments below!

End Slate Music:
“Disco Time” (by Tentacles)
Licensed under Creative Commons:


Post time: Mar-12-2018
WhatsApp Online Chat !